How To Remove 4L60E Trans. If you remove the speedometer drive gear from a 4l60e, this is the time for its reinstallation. 2 follow these 6 steps to remove transfer case from 4l60e transmission.
Transmission vent hose from the transmission. There will be a few changes to the pins at the transmission plug, and at the pcm plugs. How many quarts does it take to do a fluid and filter change on a 4l60e trans?
If you remove the speedometer drive gear from a 4l60e, this is the time for its reinstallation. Have a large bucket ready to catch the fluid that will inevitably drip all over you. I like to remove all the bolts except for those in the corners and then select one corner to drop lower than the others.
The dipstick has one hold down bolt and then it just pulls straight out. Thtool it is fairly simple to make a 4l60e harness from a 1/2 ton l truck work with a 4l80e transmission. As always, start with adding a few quarts of atf when you have the new filter and pan back on and shift through the gears to get fluid moving and warm, then keep checking and added until you have the right level.
With your vehicle raised, let the engine idle for a few minutes, then turn it off. First remove the transmission pan. When the transmission fluid is still warm, but the vehicle has cooled down, you’re ready to remove the old transmission fluid.
You should not have to remove the dipstick tube to replace valve cover gaskets. How do you drain a 4l60e transmission? Plug all openings in the transmission and the oil cooler lines.
This formally marks the completion of the 4l60e transmission rebuilding process. The rear is held in by 2 straps with 4 11mm bolts on the rear pinion. Removing the linkage (only for 4×4 shifter) 2.5 step 5: