How To Fix A Recoil Starter Pulley. Maintain a firm grip on the recoil pulley while rotating it in a clockwise direction. It will prevent the pulley from rotating in the opposite direction.
In this case, you simply need to replace the starter pulley. Remove the recoil housing cap. If the spring is uncoiled, you can recoil it again.
Remove the bolt in the center followed by the cap and the pulley on the starter housing. A small tab on the pulley can cut your hand if you accidentally let go of the recoil starter when it is tensioned. The starter rope must follow the rotation of the pulley.
Remove the starter assembly and check it out if it’s functional or not. Slide the grip onto the other end and of the rope and tie another knot, then let the pulley slowly unwind until the grip is held against the housing. Remove the starter from your generator to access the recoil spring and the pulley.
Need help replacing the starter pulley kit (part 530071966) in your poulan chainsaw? Keep the pulley rotating until the recoil housing pores and the pulley’s pellets are in the same position. Unscrew the cap that holds the pulley to the recoil starter housing.
You can access the rewind spring through the tiny screw at the center of the pulley. Install the pulley retainer over the pulley. You can then put the starter back on the engine.
Install the new recoil pulley. Additionally, the spring is responsible for putting the pull start back into place on the puller whenever the pulley is on. Hold the starter pulley in.