How To Remove Stuck Intake Gasket. I think that the hole in the intake is not threaded and the bolt goes through the manifold and threads in to the head. Use a razor blade to remove old gasket material.
How to replace a intake manifold gasket in your car diy with scotty kilmer. Optionally, use a rubber mallet to hammer from the side, cracking the gasket until it releases. This is a diy on how to remove the intake manifold on 1.8t vw audi cars:
I just removed the intake manifold and the manifold gasket is stuck onto the head and the intake. It wasn't great, but it did soak in and let me lift most of the stuck areas pretty well with a razor blade gasket scraper. There are many types of gasket removers that feature low voc, in some cases improving upon a particular gasket material depending on what part of the surface it applies to.
And scrape back and forth. This is a diy on how to remove the intake manifold on 1.8t vw audi cars: I also tried a screwdriver, but all it did was break the gasket into little chucks.
It was plastic with rubber seals and. Some intake manifold gaskets also seal engine coolant, and if the gasket wears out it may lead to a coolant leak. There are dedicated chemicals available for this job (unsurprisingly called gasket remover), which make scraping off the old gasket really easy.
If you aren't like me, move to step 4. If this isn't available, it is still possible to scrape it off, but will require lots of patience and finesse. Learn how to replace an old gasket that is causing a vacuum leak or remove the intake for polishing.
So basically hold it straight up, at a 90. Get a good, strong blade holder from a hardware store and just start scraping. I tried scraping it with a razor blade but it still pretty tough to get it off without marking the aluminum.