How To Jack Up My Car For An Oil Change. This is because you need enough working room, especially if you are to change oil, brake pads, or any underneath compartment. If you use a ramp, it’s wise to have someone watch while you drive up onto it to ensure you don’t drive too far and fall.
Oil Change: Car Ramps Vs. Jack Stands (Which Is Better?) from www.floorjackshop.com
In case your vehicle has a high profile, your size choices should be of the bottle types of jacks. Use the bricks to chock the rear wheels, pull the hand brake and leave the car in gear. Wipe away any excess oil on the rim before replacing the plug.
1990 Gas Club Car Oil Change.
Pour until the oil is just below the lower rim of the fill hole, then stop. You can either use two jacks positioned on either side of the front of your vehicle or you can use a set of ramps onto which you drive your vehicle. It raises the car an extra 3 inches off the ground.
Raise The Front Of The Vehicle And Place It On Jack Stands.
Do not use any other type of oil besides hydraulic jack oil. You need jack stands, parking brake on, and preferably wheel chocks. Wipe away any excess oil on the rim before replacing the plug.
Take A New Oil Filter And Place It Tightly.
Lay the 2×4 across the frame and jack up that way. Remove the oil filter while it drains. Place a pan in front of the drain hole.
In The Second Step, You Have To Remove Old Oil From It, Which Is Not So Far Good Now.
If you use a ramp, it’s wise to have someone watch while you drive up onto it to ensure you don’t drive too far and fall. After doing so, remove the plastic undertray (if your car has any) and reveal the oil pan. Fill the reservoir with hydraulic jack oil.
I Always Also Keep The Jack In Place In Case A Jack Stand Fails.
That's just perfect for changing the oil on most front wheel drive cars with the bolt in the back of the oil pan. Then drive your car on top of it. Make sure that the oil has drained out completely.
