Video Bass Boat Jack Plate Replacement Walk-though (18ft Fiberglass Boat)
CHANNEL YOUTUBE : Jenkins Bass Fishing
How To Install A Manual Jack Plate. Reuse the inner threaded plate that came with the jack plate. Place the car jack on the base and, using a sturdy length of wood, approximately 2 feet in length, raise the wood on the car jack until it is flush with the bottom of the engine.
Diy Jack Plate For Small Outboard Motors - Youtube from www.youtube.com
Videos you watch may be added to the tv's watch history and influence tv recommendations. A jack plate is a plate that you mount on the transom of the boat’s hull. Install the 1/2” bolts provided going thru the elbow component into the jack plate.
Mounting Holes On The Jack Plate.
Videos you watch may be added to the tv's watch history and. How to install bob's machine action jack plate and dual power poles. Locate the (2) 1/2” mounting holes on either the port or starboard side of the jack plate.
We Recommend The Use Of A Box End Wrench, Open End Wrench Or A Socket.
Any ideas with these concerns? Place a board or some other sturdy base below the jack plate. Here is a complete video, all parts sold by bob’s machine!
More So Than Before The Jack Plate Installation.
Move the engine into position. The owner says the boat does, in fact, have a tendency to porpoise ever so slightly at full trim and wot. This plate gives you the ability to raise the plate up or down.
Place The Car Jack On The Base And, Using A Sturdy Length Of Wood, Approximately 2 Feet In Length, Raise The Wood On The Car Jack Until It Is Flush With The Bottom Of The Engine.
Loosen any supporting bolts on either side of the jack plate, as this will allow the jack plate to move vertically. Instead of directly onto the hull. Install the 1/2” bolts provided going thru the elbow component into the jack plate.
How To Install A Bobs Machine Action Series Jack Plate & Dual Power Poles.
After that, it’s a matter of choosing length. Manual jack plates adjust the height of your engine manually with bolts/nuts instead of with hydraulics. A jack plate is a plate that you mount on the transom of the boat’s hull.
