How To Fix Loose Clutch Lever. The clutch lever is extremely loose and hits the handlebar before it is fully compressed. Turn that knob, and your clutch cable will tighten up.
Videos you watch may be added to the tv's watch history and influence tv recommendations. Go to your local ace hardware and pick up some tiny rubber washers and slide them in top and bottom of the lever. The clutch lever is extremely loose and hits the handlebar before it is fully compressed.
There was still some slop so i laid two small strips of duct tape in the clutch handle hole then pressed in the stock bushing sleeve, two mylar washers on top and reassembled. Slowly pull the lever, and allow any fluid or air to escape past your finger. So i opened the clutch fluid reservoir, and noticed that the fluid was grayish in color.
Roll under the car and locate the clutch pedal assembly, which is along the firewall. The only solution is to buy a new bike. Maybe you just need to give more tension to the cable using the threaded cable holder in your lever.
Turn that knob, and your clutch cable will tighten up. You should quickly get enough pressure to forcible push your finger out of the way. I used two on top and stock bushing sleeve on the bottom.
A cable is just like a chain, after use it will stretch. Setting the cable slack is not only easy to do, it’s necessary if you want your clutch to work properly and last a long time. It is possible for it to become distorted.
We’ll show you how to set your. Also you can adjust lever throw with the numbered dial on the inner edge of the clutch handle. The firewall is the divider between the engine compartment and the footwell in the car.