Video How to Change Oil and Oil Filter on a Yamaha 150 hp Four Stroke Outboard by DIYeasycrafts
CHANNEL YOUTUBE : DIYeasycrafts
How To Change Oil Filter On Yamaha Outboard. Some maintenance steps, like visual inspections, are best done every day, while others, such as oil changes, are set up at certain intervals. This will help create a snug seal and allow for easier tightening.
Quicksilver Yamaha Outboard Oil Change Kit from www.walmart.com
Remove the oil filler cap and allow the oil to drain down the side of the engine and into the oil change container. If you removed the drain screw to empty your oil, install a new crush gasket and reinstall the drain plug. Then pull the stick again and check the oil level.
With The Top Cowling Removed, Trim The Motor Down To Access The Oil Filter At The Bottom Of The Engine On The Left Side.
Oil and filter service on a 2003 yamaha f25tlrb 25 hp four (4) stroke outboard. This helps ensure proper venting for accurate indication. Remove the dipstick from the right side of the engine.
Then, Find The Drain Plug And Socket On.
Using your gloved finger, take a bit of oil (new is best, but used is ok as well) and spread it around the gasket of the new filter. Use the manual transfer switch on the side of the engine to verify oil is flowing through your new filter and the system is primed. Wait for the old oil to drain out, then install a new crush washer (included in the oil filter kit) and reinstall the 14mm drain bolt.
There Are Four Steps To Changing The Oil In Your Boat, These Are:
Put a drain pan under the outboard, and remove the 14mm oil drain bolt and crush washer from the right side of the upper casing. You are ready to begin your engine service. If you removed the drain screw to empty your oil, install a new crush gasket and reinstall the drain plug.
When Complete, Reinstall The Tank Into The Bracket And Remove The Cowling From Your Engine.
How do i change the oil filter on my yamaha t9.9gpxr outboard engine? Yamaha also offers approximately 2,000 authorized yamaha marine dealers from coast. It collects the “bad stuff” as it circulates, and therefore, it must be filtered before returning to the engine again.
Remove The Engine Cowling, Followed By The Oil Fill Plug.
How often should 4 stroke outboard oil be changed? • back the drain plug out with the socket wrench, and be sure to have the oil pan right under the plug because the oil will flow freely. • once all of the oil has drained, wipe up any excess oil with a rag or absorbent pad.
