How Does A High Lift Jack Work

One Of The Pins Holds The Pressure While The Other Is Freed And Moved To The Next Hole Above.

The working of a high lift jack jeep is pretty simple and straightforward. The hydraulic jack works on the simple principle i.e. About press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new features © 2022.

With No Load On The Jack And With The Reversing Latch (Part C4 Or S4) Locked In The Up Position, Grasp The Handle Socket (Part #C2 Or S2) With The Right Hand And Lift The Running Gear (Part #Rgc Or Rgp) Slightly Upward To Relieve The Climbing Pins (Part #29);

When using the jack as a winch: Using the jack on curved or tubular vehicle bumpers will result in the vehicle slipping off the jack and falling, causing serious injury or death. There are two climbing pins on a high lift jack, which alternate up the bar’s set of holes.

The High Pressure In The Working Cylinder Presses The Ball Firmly Into The Valve Seat, Thus Preventing The Hydraulic Oil From Flowing Back Into The Pump Cylinder.

Ensure that the beveled end of the climbing pin is facing in on the jack with the beveled side pointing towards the top of the running gear. All the work is done by the running gear, with the spine acting as a ladder for it to climb. Jacks are pieces of material handling equipment that uses force multiplication to lift or move heavy loads.

Always Use Chains Or Tow Straps That Have A Greater Working Load Than The Jack.

Putting the springs into place and dropping in the climbing pins. How does a high lift jack work? Basically, the hydraulic jack working is based on the movement of hydraulic fluid from the pump chamber to the cylinders and this movement can be done many times in order to lift weight higher and higher.

About Press Copyright Contact Us Creators Advertise Developers Terms Privacy Policy & Safety How Youtube Works.

Among the two pins, one pin carries the load as the other one is released and relocated to the following hole over when supporting or below when lowering the rig. Then with the left hand pull the climbing pins outward, thus compressing the climbing pin spring (part #28) and release the. Sometimes you need to get up, like waaay up!